PLEASE POUR THE PRODUCT INTO THE ENGINE OIL FILLER PORT
Steps For Using G-LAY :
1. SHAKE HARD the pack of G-LAY for least 1 to 2 minutes. Make sure there is no harden substance..
2. Warm up the engine for about 1 minute before application.
3. Pour G-LAY into the ENGINE OIL FILLER PORT.
4. Start the engine and let it idle OR drive for 5 to 10 minutes to let the G-LAY mix with the engine oil.
5. Warm up the engine / drive the vehicle everyday for at least a week for at least 5 minutes (for drivers who seldom drive).
Things To Take Note
We DO NOT recommend to use G-LAY on the following:
1) If vehicle is due for servicing within 5000km.
2) If ENGINE FLUSH was not done for the last few servicings (the oil sludge will dampen the effects of G-Lay).
The best effects can be seen if applied the G-LAY after ENGINE FLUSH and OIL CHANGE.
For low mileage/new vehicles (min. 3000km mileage) G-LAY will not have much visible effects but it will form a protective layer inside the engine, protecting the engine interior.
1 pack G-LAY to be used for 600cc to 1999cc engines.
1 pack of G-LAY-Small Engine to be used for small cc engines, gearbox etc.
2 packs of G-LAY is recommended for engines above 2000cc / turbo / diesel vehicles & vehicles with 150000km & above mileage.